Piper 1 (v2) 3D Printer build

Tools you need to make 3D printing less stressful

Piper 1 (v2) 3D Printer build (Part 2)

Piper 1 (v2) 3D Printer build (Part 3)

Piper 1 (v2) 3D Printer build (Part 4)

Can You earn money from 3D Printing?

The ultimate build plate adhesion

What is 3D printing

I have been meaning to do this for some time. I had the power supply and the switch but never seemed to get the time to put it all...

If you find that you can cook bacon on your stepper drivers or the motors they control there is a way to stop that happening. I have been...

I have been using glue stick most of the time during my journey into 3D printing. I tried all the other things and glue stick seemed the...

I was talking to a friend who has a Delta printer that he built. He said, “I wish my Delta had a build plate that I could level the...

One of my 3D printers is a FLSON Cube it has a good size build volume of 260*260*350mm. On this type of printer, the Z axis is handled by...

I have three printers one is a nice little Hictop Pruser i3 clone, like in the picture below. It’s in my bedroom, well was in my bedroom...

Now I have finished writing I have a little more time to put towards other projects. You might think that I have many important things to...

I have written a few books before, although they were about a completely different subject. But that for me is the reason you write a...

Delta End Stops I think that printers “End Stops” are the second most important thing on a 3D printer. Not sure what the first most...